RFMW Design An Article Resource for the RF & Microwave Design Community

Home About Us Contact Us Submit an Article Links
Categories
RF & Microwave Design Articles Wireless Technology
Amplifiers Matching Phased Locked Loop (PLL) Smith Chart  Bluetooth: iBurst OFDM
Antennas RF Mixers Receiver Design RF/RFIC Switches 3G UWB GPS
Attenuators Phase Shifters RF PCB Design VCO HSDPA WiMax ZigBee
 
Receivers
Articles on designing wireless Receivers. The Articles cover various CMOS, RF CMOS Receiver designs for ZigBee, Bluetooth, GPS, Wireless LAN and other technologies.
 
ARTICLES & TUTORIALS ON RF RECEIVER DESIGN
-

The Design of a CMOS GPS Receiver

An overview of receiver design for GPS Applications. This presentation goes over CMOS LNA design, Active Filters, Mixers, Receiver Implementation and Experimental Results.

By Derek K. Shaeffer, from Stanford University

 
-

Design of a 2.4 GHz Fully Differential Zero-IF CMOS Receiver Employing a Novel Hybrid Balun for Wireless Sensor Network 

A differential zero – IF receiver is designed on a 0.18um CMOS process for 802.15.4 ZigBee Applications. It consists of a hybrid Balun, differential cascode LNA, passive mixers and active RC Filters. 

By Shinil Chang, Jubong Park,Kwang-Ho Won, and Hyunchol Shin

 
-

CMOS RF Receiver Design for Wireless LAN Applications

This paper goes over the design of a RF CMOS receiver operating at 2.4 GHz for spread-spectrum Wireless LAN applications. The device is fabricated using 0.6 um CMOS process and has a supply voltage of 3 V, with a gain of 34 dB while dissipating 80mW of power. Dynamic range and linearity requirements of A/D converters are also discussed.

By Behzad Razavi , from The Electrical Engineering Department , University of California, Los Angeles 

 
-

A 5.2 GHz CMOS Receiver with 62-dB Image Rejection

This paper describes a 5.2 GHz CMOS receiver based on a downconversion hetrodyne architecture with a local oscillator frequency of 2.6 GHz which applies offset cancellation to the base-band amplifiers. The receiver has a noise figure of 6.4 dB, an IP of 15 dBm , and a voltage conversion gain of 43 dB, while dissipating 29mW from a 2.5 V supply.

By Behzad Razavi, Member, IEEE

 
-

RF Design of a Wideband CMOS Integrated receiver for Phased Array Applications

This paper outlines receiver Front End Development including the design and simulation of an LNA using a wideband input-power-match for noise cancellation. The Receiver is designed to operate at frequencies between 500 MHz and 1700 Mhz. It consists ofa an LNA, band pass filter, quadrature mixer, anti-aliasing filter, digitiser and serialiser. It is fabricated on a 0.18um CMOS process.

Suzy A. Jackson from CSIRO Australia Telescope National Facility and Macquarie University, Sydney,Australia. 

 
 

 

 
Micorwave components and RF Components
Search for RF and Microwave Components from multiple suppliers
 
RF Amplifiers
 
Antennas
 
RF Attenutators
 
2 Way Power Divider
 
3 Way Power Divider
 
4 Way Power Divider
 
6 Way Power Divider
 
8 Way Power Divider
 

 

© 2010 everything RF - Search for Microwave Components All Rights Reserved. Sitemap
Privacy Policy - Terms of use